ToughLED Pro
ToughLED Pro
JCC ToughLed Pro LED Battens in Stock
Our new ToughLED™ Pro range is the culmination of feedback from over one hundred electrical contractor Interviews. We watched, listened and learnt to gain an understanding of the key areas that hampered electrical contractors when installing traditional weatherproof fixtures. Our Design and Development team then took this information as the brief to improve all aspects of installation, from wiring access, IP maintenance, side clip mechanisms to simple points such as laser level and internal drilling guides.
ToughLED Pro features side fastening clips that can be secured into a 90° position to ensure they don't get in the way during installation or when attaching the diffuser.
ToughLED Pro features a detachable 4-way loop-in/loop-out terminal block that can be positioned in four locations along the base to meet any cable entry point. 180° rotatable terminal block to meet any cable point.
ToughLED™ Pro features a two-part lockable IP66 surface mounting gasket to maintain ingress protection for rear cable entry when surface mounting.
Cable restraints are positioned along the fitting to ensure cables are secured neatly and avoid interference with the diffuser and internal gear when closing the fixture.
The main body of ToughLED Pro is wide enough to ensure coverage when retrofitting and the correct width for BESA conduit boxes. All fixing points are marked on the outside and inside of the ToughLED Pro base. Pilot guildes ensure accurate pre-drilling and fixing of BESA conduit boxes.